Wednesday, December 9, 2020

Pork chops, running and cast bullets

 

 

Mrs ERJ believes that Human Nutrition requires ample amounts of green and yellow/orange vegetables daily.

I do my best to accommodate her. Broiled pork chop coated with corn meal, salt, pepper, garlic and onion powder. Potatoes covered with yellow/orange cheese.

Running

Once again I was defeated by technology. I don't know if the screen bounces against my leg and resets? I just don't know.

My plan for tomorrow is to walk the course and tie surveyor's tape at the one mile marks. Then I can drop back to low-tech, $15 wristwatch with a timer function.

My best estimate is that I ran 11:40 minutes-per-miles.

Cast bullet rabbit hole

There are a couple of go-to sites for cast bullets. One is the LASC site. The other is the Cast Boolits site.

There are multiple factors that interact that make it almost impossible to give advice that is universal.

For one thing, the hardness of a cast bullet changes as it ages. One shooter may swear by 12 BNH bullets but did he measure them immediately after casting or after a month on the shelf?

For another, many casters don't have a way to measure hardness. They look up references and assume their wheel weights are identical to the ones measured in the reference.

Then there are interactions with lube, bullet geometry and gun geometry.

Then there is the complication that the bullet's base must obdurate when the base of the bullet is fully engaged in the rifling somewhere forward of the chamber. The speed that the pressure drops off as it moves down the barrel varies between large-capacity, designed-for-blackpowder revolver cartridges and small-capacitiy, designed for smokeless semi-auto cartridges.

In the end, simplicity wins. Glen E. Fryexell of LASC wrote

...for routine sixgunning applications what do we want from our cast bullet alloy? In the 800-1000 fps range we should probably keep the alloy at a BHN of 12 or below. From 1000-1400 fps, 12 to 16 is a very useful range of hardness. For velocities of 1400 to 1700 fps, this window slides up to 14 to 20. Above 1700, linotype at a BHN of 22 is an excellent choice.

Since most bullets cast from wheel-weights that are air-cooled now vary between 12-and-14 BHN two weeks after casting, bullets intended for .38 Special probably benefit from a blend of 2/3 wheel-weights and 1/3 "pure" lead. That can be expected to throw bullets between 10 and 11 BHN.

Bullets that are air-cooled and aged a couple of weeks are probably suitable for 9mm but I will appreciate anybody who actually casts bullets and shoots a 9mm or 40S&W.

This is actually a great time to buy pure lead. It is available on eBay for a reasonable price because so many cities are ripping out the lead water service lines because of the problems highlighted in Flint, Michigan. 

2 comments:

  1. I've never found a lead pipe that made good bullets. Most of the "rip-outs" are so corroded that the amount of dross you get is more than half the weight of the lead. I don't like paying shipping on something I am going to throw away.

    Cast bullets are a rabbit-hole, and it's easy too over-think it. For black powder velocities, pure lead works great. For magnum revolver, wheelweights are fine. For rifle velocities under 2000 fps, a little Linotype in the mix works well.

    ReplyDelete
  2. And Paw knows of which he speaks... Yes, it truly IS a rabbit hole!

    ReplyDelete

Readers who are willing to comment make this a better blog. Civil dialog is a valuable thing.